Bit of a long shot.... has anybody got the printer utility for flashing firmware on an orient printer please?

Shouldn’t really need to change any settings on the router. Set up your own ‘internal’ network on a standalone switch, with all the tills and pc connected to this switch. Test network functionality on...

i'd go with a separate switch for the epos stuff, tills, pc etc, use a different ip range for all your epos stuff, drop a link from this switch to the outgoing router for remote access. you can set an...

25 pin 1 --> 8 2 --> 3 3 --> 2 4 --> 20 5 --> 7 6 --> 6 7 --> 4 8 --> 5 9 --> 22 9 pin 2 --> 3 3 --> 2 4 --> 6 5 --> 5 6 --> 4 7 --> 8 8 --> 7

are you using a 9 pin or 25 pin at the printer end?

if you can send me your logo, i can do a conversion for you

are you programming on the till or with the cv33 software? If you're using the software, just go on and add a new menu button and download the updated keyboard to the till, easy peasy i've posted li...

Go to z mode and z all clerks and all checks, let's should work after doing this

From what I remember, you need to edit the config file to match the IP address of your till, use a crossover cable for direct connection or a standard cable if you're using a switch

Okay folks, I tried to make it easy for you but that wasn't working. For all you people out there that require this software, I will send you a link yo the downloads YOU NEED TO INCLUDE YOUR EMAIL ADD...

after you enter the new name, press the 00 button, (might be labelled B) then cash, then subtotal

have you got an operator logged on when you turn to PGM mode?

password for the software should be the current date, entered in reverse, eg 20121120 for today

turn it off at the main power, hold down the receipt feed key and turn it back on, display should show a row of FFFFFFFFFFFF, press subtotal, this should reset the machine, then try to load your prog ...

anybody know anything about Zonal systems, i think the software on it Aztec, i,m trying to bypass the epos software starting up so i can install/calibrate a new touch panel, so far, its not going well...