Hi Set the mode switch to the Z/PGM position, then operate the following key sequences. Date (DDMMYY) #/ST (#/ST: to finish programming) Time (max. 4 digits in 24-hour format) #/ST(#/ST) You can chang...

Hi Ok there is a small bit of setting up, first need to know the following Is there a barcode scanner going on it and second do you have a service key for them? Regards Tillman

Sent you a pm on it

When setting up your QT6000 on the branch settings you have to put in the correct IPL which is on the machine then you have to put in the MAC code in as well. Unfortantly this machine doesn't like usi...

Hi If you are using a standard comms cable this wont work on the till. You would have to make up a cable by getting 2 RS-232 modules with covers and solder the cable to the pin outs that Dave gave you...

So let me get this right, you want to be able to count your stock levels as you sell your products, would i be right on saying that? Tillman

Hi Tom Press the Mode button and go to PGM1 button, then type in the time in 24HR format and press the " X date time button " it is usually the multiply button and the time should come up on...

Hi Adam Do you know what MAC code was put in to the machine? To find this turn the key to the off position, then press the receipt feed button and keep it pressed down at the same time turn the key to...

Hi Candy Can you give me the model number of the machine you have so i can get the info you need Regards Tillman

Hi When you reset the till back to factory default did you open the files for PLU and WLU to match the other 2 machines? If these files are smaller the the other 2 this would cause it to fail Tillman

Hi Is it sam65 utility software you have? if so you prob have to set up a com port on the till. Let me know what software you have and i should be able to sort it out for you Tillman

Hi Tom Could be possible that there might be a fault with your software. If you send me a message with your e mail i can give you the lastest copy of the software which is now called CV 32 Tillman

Hiya Just a quick question. Is it possible to have compulsory sign on for clerks on this model? If so whats would be the code to set it up on? Regards Tillman

Hi Chris Have a template program here with that model on it but unfortantly it does not allow me to export to excel or word, but on the manual there should a picture of the template if you were able t...

Hi Have a template program that has the ER A570 on it but unfortantly there is no way of exporting it to excel or word. If you are badly stuck i can do it up here and post you a copy or two Regards T...