Welcome to EpoS Wizard!
We have a Sam4s ER940 Cash Register, and we have reprogrammed a key for Received Acct 1. But when we try to use it, when I press the Cash key as part of the sequence, it gives a Sequence Error. I do not think it is incorrect.
Any ideas?
Sure - my idea is - you programmed it incorrectly 
the RA button works straight out of the box!
Sure - my idea is - you programmed it incorrectly
the RA button works straight out of the box!
OK, less than helpful. But you get to feel smug.
Anyone else have any useful suggestions?
OK - so sense of humour failure aside - lets get started.
s mode
70 into sub total
193 into relevant button to be RA
cash total.
p mode
70 sub total zero RA1 button cash
90 sub total zero RA1 button cash
job done
Reg mode
press RA1 enter amount - eg £5 would be entered as 500 NO DP
press the method that the value was received - ie cash, cheque or credit button.
press RA1 button again to complete.
have fun 
OK - so sense of humour failure aside - lets get started.
s mode
70 into sub total
193 into relevant button to be RA
cash total.p mode
70 sub total zero RA1 button cash
90 sub total zero RA1 button cashjob done
Reg mode
press RA1 enter amount - eg £5 would be entered as 500 NO DP
press the method that the value was received - ie cash, cheque or credit button.press RA1 button again to complete.
have fun
The till I have does not have an RA button ready out of the box, which was why it was not so helpful.
I had carried out the S mode instructions, but not the P mode- what does the two P mode 70 and 90 instructions do? They are probably what I was missing.
Thanks.
