Welcome to EpoS Wizard!
PLU data not passing to Slave Station
Page 1 / 2
Next
Posts: 0
May 17, 2020 3:17 pm
I have two Stations running ICRTouch V2.66.2, one as master and second as a slave. They have both worked fine until now newly created PLUs and Keyboard layouts are not carried over to slave station? I had a brief message on master a while back saying max PLUs reached......
My table plans and ordering seems to still work?
Timo
Reply
9 Replies
Posts: 0
May 17, 2020 3:23 pm
Have you got the same maximums set on both tills? Program 5.
Reply
Posts: 0
May 17, 2020 3:55 pm
Yes both the same...
PLU 1000 (65000)
LIST PLU 99 (999)
and so on...
Should I up any particular file sizes?
Reply
Posts: 0
May 17, 2020 4:03 pm
Not if you don't need to.
Sounds like your tills are out of sync. Run an IRC Initialise and then send 'All AB' from the till with the right program.
Reply
Posts: 0
May 17, 2020 4:17 pm
The send ALL AB did the trick, THANK YOU Simon!
Reply
Page 1 / 2
Next
Forum Information
Our newest member: hadles13
Latest Post: Casio (QT6600) CV33 Software
Forum Icons:
Forum contains no unread posts
Forum contains unread posts
Topic Icons:
Not Replied
Replied
Active
Hot
Sticky
Unapproved
Solved
Private
Closed