Sp122 plus should enable you to do all plu programming for all plus in the till. Plm is not needed.

Log onto the till with the engineer code in key position SP. Select program funcs if you need to and SP140 Logo Lines Wide should be your receipt text

Have you checked the model numbers are the same. Xn900 come in two revisions with different resolutions. Look for XSLA or XSKA model numbers. Hopefully both have the same model number.

Doesn't take much to set it up for receiving a program. I would be concerned that the battery may not be up to much since it lost its program so I would try to avoid turning it off in future. The set...

I suggest finding an icr dealer and asking for a demo. The software is only available through the icr forum which only open to dealers. Good bit of kit though. Much better to have it on Android than o...

There are different specs for different revisions. The various model numbers on the xn900 denote different hardware revisions inside, to change an XSKA (800x600) to an XSLA (early 1024x768) you'd need...

SP850 Touch Screen Layout Add the hard PLU's to the screen. SP111-PLU Menu To allocate PLU's to the Hard PLU Buttons

You're better off changing the printer config to match your old printer, rathe than changing flags in the till. What is the model of printer?

If you're buying for a hospitality enviroment then I strongly suggest looking at ICR. Of the several PC based systems I have experience with ICR remains the most stable. As for hardware, I've yet to c...

First thing I would do is make a back up. You can find the back up utility here.. start menu/all programs/total contro/utilities/backup restore This can take a while. Make a note of where it's backing...

They have to be connected over a network yes. To make sure they are connected there should be a button called inline functions, again it can usually be found in the manager mode. This is also where yo...

Go to home. press Manager mode. There is normally an option to send in there, but you will have to be logged in as a clerk with permission to send. Also make sure you send from the till with the new c...

Fidelity should be able to suggest a dealer for you.

Obviously Touch Office (formally TMS) is made by ICR themselves and so is probably you best bet for back office linking to ICR. It is a good bit of kit. Fidelity's Total Control also links to ICR but ...

Depending on what till you have it may be easier to do plu range programming on the till itself.