Plm2000 does not support 06 till types (tills with 6 price levels) uniwell brought out unibos for these tills although it will send things in like the description and group any flag settings will be i...

if it does not work try doing the same as above with the key in SP rather than X

wedderburn cash registers in that much trouble they have to look for biz on forums now?

what model tills do you have? what Printer do you have? are the tills currently networked together? If yes using IRC or Ethernet?

to reset the till you need a "S" key turned to the reset position this is one place further on than Z1/P turn the till off at the switch on the back right hand side put your finger in the to...

the engineers code should work after a setup required I am guessing that your "engineers code" may have just been a ordinary clerk setup to behave like the engineers code

To change the system flags Key to SP log on (may need to log on with the engineers code) select program functions select SP-113 System Flags Line down to SF10 Line down to either F or E (depending on ...

what tills do you have and do you know the engineers code?

Have you tried asking Fidelity (the people who make it) if they would send you a disk?

it will really depend on two things how complicated is your menu what condition they are in (programming wise) If they are set to "Factory default" then you will have to start from scratch a...

the tx875 can have either this may be stating the obvious....But the way to tell if you currently have magnetic keys or not is to simply put one on. If it sticks to the contact then its magnetic if i...

you might find this usefull as well but cooking instructions are normally used for things like "how you want your steak done" SP-132 Cooking Instructions Create Cooking Instructions then asi...

the first thing to do will be to create the plus for chips & mash in (sp122) make a note of the plu numbers you used then go to the condiment groups (sp125) find a group that is not being used and...

you will need a serial lead,a copy of plm and a copy of the 1.15 flash file in order to upgrade alternativly it is possible to send the flash from one of the other tills using sp8888 (not listed so yo...

not really much in the way of settings on the till other than the comms settings its only really flags 58 and 59 if all this is correct then it may be a fault on the cable run between till 1 and the ...