TX 875 - fob programming

Hi,

Try this.....

1. Turn the key to the 'X' position.
2. Sign on using a managers/supervisor code.
3. Press [Program Funcs] - If this does not appear see my note below.
4. Highlight Clerk I-Buttons and press [Enter].
5. Now highlight the clerk name you want to assign the keyfob to and press [Enter].
6. The till will now display something like "Enter I-Button".
7. Now put your keyfob on, and the till should "beep" then the till will move the highlight bar onto the next clerk.
8. The keyfob is now allocated.
9. Press [Clear] then press [Clerk ID] to log back off.

NOTE: If [Program Funcs] does not appear you may not have the security permission setup to perform this task, in which case you'll need the engineers code.

Hope this helps.

Irdone.

if it does not work try doing the same as above with the key in SP rather than X

thanks very much - i will try this and see how i get on,