Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Notifications

Clear all

Micros Till running E7

Micros

Last Post by Bolsie 12 years ago

1 Posts

1 Users

0 Reactions

2,421 Views

Posts: 8

Bolsie

Topic starter

Feb 16, 2013 8:05 am

(@bolsie)

Active Member

Joined: 14 years ago

I have just bought a used Micros Till running E7 and am having trouble getting into the configuration section and I'm not sure I'm doing the right thing.
When the software is loading up (out of windowsCE) it says press C to enter configuration mode. I do this and nothing happens and it just goes into the standard menu section once I've entered the 3 digit staff number I've been given. I know the attached keyboard is working but getting frustrated that I can't get I to the programing section.
Any hell would be appreciated.

Forum Jump:

Next Topic

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed

Welcome to EpoS Wizard!

Micros Till running E7

All Rights Reserved © 2021

Terms and Conditions

Discussion Rules

Privacy Policy

Cookie Policy (UK)