Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
General Section
General Advice & Di...
has anyone "pl...
 
Share:
Notifications
Clear all

has anyone "played" with the new sam4 900 series yet?

 
Page 1 / 3
General Advice & Discussion
Last Post by porty 12 years ago
14 Posts
3 Users
0 Likes
1,598 Views
Posts: 2464
 andy-the-diver
Topic starter
Feb 15, 2012 5:18 pm
(@andy-the-diver)
Member
Joined: 15 years ago

if so, your initial thoughts :roll:

Reply
13 Replies
Posts: 859
 porty
Feb 20, 2012 10:31 am
(@porty)
Prominent Member
Joined: 13 years ago

I haven't played with them yet! However I wouldn't mind your opinion on the SPT 4000/4500s if that's ok?

Reply
Posts: 2464
 andy-the-diver
Topic starter
Feb 20, 2012 11:07 pm
(@andy-the-diver)
Member
Joined: 15 years ago

never used one but the spec on ycr's website would suggest intel atom configuration. similar to various netbooks that are on the market
cannot vouch for the build quality - though it cant be much worse than the 900's! :oops: :cry:

Reply
Posts: 859
 porty
Feb 21, 2012 8:16 am
(@porty)
Prominent Member
Joined: 13 years ago

It was the build quality I was concerned about!
I was thinking about using them as a cheaper alternative to J2s, maybe not then.
Take it the 900s aren't the best built in the world then!

Reply
Posts: 2464
 andy-the-diver
Topic starter
Feb 21, 2012 5:39 pm
(@andy-the-diver)
Member
Joined: 15 years ago

lets just say that 5200 printers - they aren't!
do you have many issues with j2 touch screens failing? [as in the touch bit!]

Reply
Page 1 / 3
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)