Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
General Section
General Advice & Di...
Epos tx 875
 
Share:
Notifications
Clear all

Epos tx 875

 
General Advice & Discussion
Last Post by Anonymous 11 years ago
2 Posts
2 Users
0 Likes
1,948 Views
Posts: 1
 Tommy golden
Topic starter
Apr 24, 2013 2:42 pm
(@tommy-golden)
New Member
Joined: 11 years ago

Hi I have 3 ex875 epos till all linked to a pc I want to remove 1 of the tills can I just unplug it of do I have to remove it from system

Reply
1 Reply
Posts: 0
 Anonymous
Apr 24, 2013 10:04 pm
(@Anonymous)
Joined: 1 second ago

If you do actually mean Uniwell TX-875s then you can unplug 1 of them - make sure it's not the 'Master' - then run an 8800 to reset the IRC correctly. On the back-office you should put the relevant till out-of-service, depending on whether you are running one of the USD packages or Fidelity Total Control.

Reply
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)