Welcome to EpoS Wizard!
Geller ET-6600 - change clerk name
I have managed to change the message that goes across the screen, PLU names and PLU prices
For some chuffin reason I just cannot fathom, changing the clerk names just will not work.
To attemp to set I have
Key to P1
start key until "cashier" appears
select key
"name" appears next
input key
I type in "A"
display changes to the next cashier
Press start again
display is "clerk ID"
select key until "name" appears
I type in "B"
display changes to the next clerk
Key back to "R" and I press the "clerk 1" key
Display briefly shows "B" then the old name !!
Do not know what happened to "A" under "cashier" above and why does it come back with the old name a second after my new name of "B" appears from the clerk name programing ?
Tried a P2 power off for 10 seconds and back on again with the key still in P2. No effect.
I have made both clerk name and cashier name both "A" and that does not work either. I am using "A" and "B" just to illustrate what is happening.
Beer money to whoever can fix this and thus restore my sanity !
Thanks in advance,
Ian
Hello
Are you trying to change clerk or cashier names? If you are using a button on the keyboard then you are using clerks.
P1
Clear
8
Start
Select
Input
(enter name for clerk 1)
input
(name for clerk 2)
input...............
Sean
SOCHEALLAIGH
donations.php
To attemp to set I have
Key to P1
start key until "cashier" appears
select key
"name" appears next
input key
I type in "A"
display changes to the next cashier
Press start again
display is "clerk ID"
select key until "name" appears
I type in "B"
display changes to the next clerk
Key back to "R" and I press the "clerk 1" key
I see what you are doing. You must press 'input' after you enter the name for a cashier eg 'A' and this will bring you directly to the next name eg 'b' and press input again
Sean
SOCHEALLAIGH
donations.php
Hi Guys,
Thanks for the posts. Bad news is neither sorted the problem.
Recap, I have "A" set via "Cashier" then "name"
"B" set via "Clerk ID" and "name"
I hit the "Clerk 1" button, for 1 second I can see "B" then it goes and stays on old staff name.
So "A" in cashier name was not being seen at all.
Depressed, I then decided to go back through the "Start" menu, past "cashier", past "Clerk ID" and when the display showed "Guest" hit "select" until "name" appeared again, pressed "input" and .... up came the old staff name !! Easy from then on.
So for some reason cashier name is not being used, clerk name flashes on for 1 second, the it settles on....guest name !
Again thanks for taking the time to respond. Just about to start using the till now so maybe more questions later !