so any luck? or do i have to program them all again? thanks for the support which ever way

sorry about the late reply went away for the weekend i have now got all tills talking but when it hits till seven if freezes due to a printer error. i think ive resolved this i have also somehow lost ...

well the good news is i can contact till 8 from the back office, when i did a network test it failed on till 7,8,9,10,11 so i reset the irc and tried to send data around it completes suc on 1-6 and f...

till eight is set as master in the software the only thing i have not done is set everything to no on the flags will try about 3 and let you know if its baud rate then i have alreadyy tried that

the last picture is for till 1 sorry, the master till is till 8 is it still the same?

ok scratch the last part looked at another thread and the answer was there all 11 tills are talking bad thing is that the pc wont talk to the master yet the pictures above are of the back office ...

thought this might help

thought this might help

well you are a genius the ram test bought all the till back to a usable state they are all numbered up like you wrote i have 2 left which are 8500 with different keyboards can i have some details for...

thanks for the email. issue i have is when i go into sp and do the intial reset it says ir done but still comes up with setup required i cannot log into the tills with the engineers code just the po...

i click init irc it runs through to 32 then tries to print but i have not set the flags correctly yet

set them all to no but still cant get th pc to talk to it i do have one till unplugged and that s the old master as it hard wired through the bar top can i put the other one back ? as the network w...

ok got into that what next please

Hi, the keys are flat. i cannot get back into the engineer mode as i cant find the correct buttons in a previous post about these tills you put a link to the key board well my buttons are set to botto...

Hi well i plugged in another till and reset but the keyboard layout has changed, managed to figure out where the buttons were, entered engineer code entered 9999 init all data. its plugged in by ether...