Hi all, Got a site with 4 x Uniwell Ax3000's, where we have had a power cut. Tills not talking to each other. How do we initialise the network? Thanks

How long have the machines been turned off? It is quite possible that the unit has lost it's firmware. If so, you have a problem.

I am looking for a S/H Sharp XEA 301/303 or simular. Can anyone help?

hi, The s key is the master key, for manager use only. X and Z keys can be set for corrections, refunds,no sales to be controlled, but primarily for taken daily reports. If you have added plu's ok, yo...

Hi, go to sp, prog funcs, 113 enter, 77 enter, set bit F to yes. That should do it.

Hi, quite a complex machine to program. Best to use a pc to start from scratch. PM me, i'll see if i can help you.

Hi, I have numerous Sx700's, pm me if you are interested.

the machines have lost all of their programs. you would require a complete reprogram, which is not straight forward. where are you based?

where are you based. send me a pm.

I have several working Tx 850/870's, and relevant printers. Send me a PM if you are interested.

Can i allocate a half pint function. what function do i set and how to i program it.

Once set these printers should not reset their ip address. You should not have to get engineers in every week. Message me if you need assistance.

Hi, Even when you get the code do you know how to configure unit. pm for assistance.

Does anyone have any Uniwell SX700's for sale,or any parts?

you have a problem with your ribbon connector to the touch screen panel, you may need to replace.where are you based?