Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
Cash Register Secti...
Uniwell Cash Regist...
Uniwell ux7000 prog...
 
Share:
Notifications
Clear all

Uniwell ux7000 programming clerk problem

 
Uniwell Cash Register Equipment
Last Post by brucej9 15 years ago
3 Posts
2 Users
0 Reactions
748 Views
Posts: 2
 brucej9
Topic starter
Oct 30, 2009 10:23 am
(@brucej9)
New Member
Joined: 15 years ago

Hi

To programme the till you must turn the key to sp and log in as clerk 1. However i have renamed clerk 1 and given it a pass code, this has caused me a problem as i can no longer log in as clerk 1 and it doesnt give me any programming options as the renamed clerk 1. HELP! how do i get clerk 1 back or get programming options?

Thanks for your help in advance

Reply
2 Replies
Posts: 10
 The EPoS Grandad
Nov 04, 2009 10:52 pm
(@the-epos-grandad)
Active Member
Joined: 18 years ago

Hi,

Do you not have any other clerks setup with programming privelages ?

Your only option will be to login as the engineer code , do you know this code ?

Reply
Posts: 2
 brucej9
Topic starter
Nov 05, 2009 10:07 am
(@brucej9)
New Member
Joined: 15 years ago

Hi

Thanks for you reply, unfortunately i dont have either of those, how could i get the engineer code?

Reply
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)