Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Share:
Notifications
Clear all

Uniwell TX850 / TX870 programming

3 Posts
2 Users
0 Reactions
862 Views
Posts: 2
 Saby
Topic starter
New Member
Joined: 12 years ago

Hi guys,

I've got 3 TX850 and 4 TX870 tills (3 of them new), all linked up, set up, connected to a pc, i can send and receive data so all connections are good.
The only problem I have can't upload all the data from the old tills to the new ones.
Did the SP8800 then SP8899 from the master till but on the new tills only half of the data shows up (clerks 1-13, i have 40, PLUs missing, buttons missing).
Any clever ideas what shall i do?

Thanks!

Reply
2 Replies
Posts: 2
 Saby
Topic starter
New Member
Joined: 12 years ago

Also tried to upload the data from the PC, same result.

Reply
Posts: 116
Estimable Member
Joined: 12 years ago

Hello there,

I,m assuming that the tx850 & tx870 are compatable
With each other ? Please provide till type and firmware version for both models

Also this sound like a clear case of different maximum setting set on both models
Under sp 112 I would check both models and see if you could
Match each other the same.

Pm me with your info

Reply
Share: