Uniwell sx700 till and Epsom receipt printer

the flag settings are confusing on this set up
if your till is stand alone and not irc multi till set up
try this ,
manual says channel B = pc coms (page 81 of manual)
CHANNEL C= ONLY AVAILABLE ON THE SX-700 & SX-800
Programmable for the following EFT or JDT or Cashless or Local receipt or scanner
refer to page 83 of manual and connect local printer via chanel C (rs232)

also refer to BAT E' S post re flag settings

system flag 86 (page 70 of manual)
h=yes
g=no
f=no
e=no
d=no
c=no
b=no
a=yes (nnn=cbm233 ,nny=tm-t8811, nyn=cr or lf ,yyy=cbm233

system flag 91 ? channel c device (page 73 of manual)
h=n,
g=n,
f=n,
e=n,
d=n,
c=n,
b=n
a=yes (cba=001 chanel c is used for local receipt)

Hi printer is now printing but just rubbish ?

Almost certainly the baud rate now then.

What are your SF31,SF32,SF33 and SF34 flag settings ? and sf45 and sf57 ?

Hi printer is now printing but just rubbish ?

define rubbish ? when replying please try and give plenty of information as this will help in understanding whats going wrong

from what i have read, baud rate is pre-set for channel c devices
however the TM88II baud rate is adjustable if it's a baud rate issue

set the baud rate on tm88ii to 19200

Hi thanks for all you help printer is now working fine.
Thanks again keith