Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
Cash Register Secti...
Uniwell Cash Regist...
Uniwell sx700 till ...
 
Share:
Notifications
Clear all

Uniwell sx700 till and Epsom receipt printer

 
Page 2 / 4
Uniwell Cash Register Equipment
Last Post by keithy 12 years ago
20 Posts
4 Users
0 Reactions
1,960 Views
Posts: 0
 Anonymous
Jul 27, 2012 12:02 pm
(@Anonymous)
Joined: 1 second ago

Check the settings on the SX, but normally runs at 19k2 baud

Reply
Posts: 66
 keithy
Topic starter
Jul 27, 2012 12:26 pm
(@keithy)
Trusted Member
Joined: 12 years ago

Check the settings on the SX, but normally runs at 19k2 baud

hi where do you check that ?
Cheers Keith

Reply
Posts: 0
 Anonymous
Jul 27, 2012 12:39 pm
(@Anonymous)
Joined: 1 second ago

Go into SP mode and check the programming for the serial ports

Reply
Posts: 48
 dave the builder
Jul 27, 2012 1:48 pm
(@dave-the-builder)
Eminent Member
Joined: 15 years ago

key to SP
system flags =113
flag 31 serial baud rate
N,N,N,N,N,N,Y,N
PAGE 43 OF MANUAL

Reply
Posts: 66
 keithy
Topic starter
Jul 27, 2012 1:52 pm
(@keithy)
Trusted Member
Joined: 12 years ago

Go into SP mode and check the programming for the serial ports

Can't find any options to change baud rate ?
Thanks Keith

Reply
Page 2 / 4
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)