Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
Cash Register Secti...
Uniwell Cash Regist...
Uniwell SX6600 scan...
 
Share:
Notifications
Clear all

Uniwell SX6600 scanner setup

 
Uniwell Cash Register Equipment
Last Post by mstorjo 10 years ago
1 Posts
1 Users
0 Reactions
718 Views
Posts: 1
 mstorjo
Topic starter
Jul 14, 2014 8:00 pm
(@mstorjo)
New Member
Joined: 11 years ago

Can anyone help me with the proper Honeywell/Metrologic bar code scanner set up info. I have the correct wiring for the cable and I have the register settings and the Honeywell configuration manual. What I need is the list of codes that need to be scanned/programmed in a Fusion 3780 scanner (or Orbit 7120,Solaris 7820QuantumT 3580. the register is a SX series for use in the United States. I have tried many combinations but I must be missing something
Thanks, Marc
Register settings: (which I cannot change because there are 2 registers)
RS232
Even Parity
7 Data bits
1 bit stop
9600 Baud rate
I believe but not sure I also need
RTS/CTS Handshake on
Message RTS/CTS
STX Prefix on

Reply
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)