Welcome to EpoS Wizard!
HELP ME PLEASE!
I managed to completely jam the Uniwell SX-8505 till at my bosses pub! Basically, the CL (clear button) and the ENTER button do not work - I was messing around with the till and some how re-programmed them both as something else.
How do I access the default keyboard layout so that the ENTER and CL key can be re-programmed to what they should be.
I have tried holding down the three X buttons, turing the machine off and then back on. However, I don't see F0 anywhere on the screen at all. There are a couple of lines that say ROM or something like that.
Anyhow, when I hold the X's down, turn it off and then back on, when I am on the screen with the ROM thing, I can selet 1 and then clerk id, but it takes me to the program function key screen which is where it's stuck.
Does anyone know the engineer code so that when I do the holding the three X's down procedure, I can type in the engineer code instead so that I can re-program the enter and CL keys?
I am not sure if this is how you do it, but any help would be much apprecited. My email is gary.john.bell@hotmail.co.uk!
I need someone to tell me how I access the default keyboard in basic steps, i.e. turn key to this position, press these buttons, turn off, go to this etc etc. I don;t know any codes for the till at all!
You need to toggle to the default Uniwell keyboard which on your will be F0.
To toggle between F and C (C=Raised keyboard F=Flat)
turn key to SP
Turn the till off
You need to hold down 3 buttons
Goto the bottom left hand corner of your keyboard.
Got 5 rows up and hold down that button and the 2 buttons next to it.
Turn the till on while holding the butttons down.
You should see F1, F0 or C1 or C0
To toggle between 1 and 0 (1=Programmed and 0=Default)
turn key to SP
Turn the till off
You need to hold down 3 buttons
Goto the top left hand corner of your keyboard.
Go 4 rows down and hold down that button and the 2 buttons next to it.
Turn the till on while holding the butttons down.
You should see F1, F0 or C1 or C0
You want F0.
Use the default keyboard and when your finished toggled back to F1 for your programmed keyboard.
