Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
Cash Register Secti...
Uniwell Cash Regist...
Uniwell EX570 - Pro...
 
Share:
Notifications
Clear all

Uniwell EX570 - Programming Help!

 
Uniwell Cash Register Equipment
Last Post by Anonymous 11 years ago
1 Posts
1 Users
0 Reactions
871 Views
Posts: 0
 Anonymous
May 02, 2014 4:26 pm
(@Anonymous)
Joined: 1 second ago

I am reprogramming an EX570 till that had PLUs previously programmed. All the group names, prices and PLUs were different so I did an 'Auto Preset' and started from square one. I now have all my PLUs/prices/look-up assignments/group names programmed and switched over the register 'R' mode to view and no info is there. How do I make all my programmed data accessible in the 'R' mode so we can start using the till?

Thanks!

Reply
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)