Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
Cash Register Secti...
Uniwell Cash Regist...
Uniwell dx-915 - en...
 
Share:
Notifications
Clear all

Uniwell dx-915 - engineer mode issue

 
Uniwell Cash Register Equipment
Last Post by Anonymous 10 years ago
3 Posts
2 Users
0 Reactions
891 Views
Posts: 0
 Anonymous
May 13, 2014 6:56 pm
(@Anonymous)
Joined: 1 second ago

Hi Folks

I have a dx-915 which I am trying to programme at the moment. I have all of the relevant guides and have been able to enter engineering mode the first couple of times, however for some reason when i have gone into "SP" mode again it is not accepting the code which brings up the menus on the left of the screen.

Also although I could initially enter engineer mode the on screen keyboard has never displayed.

Do I have a corrupt system? am i missing something?

Any help would be gratefully received

Cheers
Steve

Reply
2 Replies
Posts: 0
 Anonymous
May 18, 2014 8:21 am
(@Anonymous)
Joined: 1 second ago

Hi Steve,

This certainly sounds like corruption. Have you tried a 9901 in the 'blind' position to completely clear down all the memory?

Reply
Posts: 0
 Anonymous
Oct 15, 2014 2:29 pm
(@Anonymous)
Joined: 1 second ago

I need help with the Engineer's code,am unable to go into engineering mode on my DX795 but I know the rest of the procedure.Need to do a setup of the machine...

Reply
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)