Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
Cash Register Secti...
Uniwell Cash Regist...
SX 700 Networking a...
 
Share:
Notifications
Clear all

SX 700 Networking and engineer code

 
Uniwell Cash Register Equipment
Last Post by chisholmchris 15 years ago
1 Posts
1 Users
0 Reactions
475 Views
Posts: 9
 chisholmchris
Topic starter
Jun 30, 2010 4:09 pm
(@chisholmchris)
Active Member
Joined: 16 years ago

Hi

Ive just taken over a bar and have 3 sx700 tills linked but one of the tills is now broken so i cant run any irc as it says it cant be detected.

Is there any way of tell the system that its not there anymore also could i please request the engineer code off somebody please as i do not have it.

If it would be easier I am thinking of wiping them completely and starting again as the products i want to stock now are nothing like the ones that have been sold in the past.

Thanks in advance

Chris

Reply
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)