Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Share:
Notifications
Clear all

SX 6600 programming from factory setting to connect to ePos

2 Posts
2 Users
0 Reactions
795 Views
Posts: 2
Topic starter
New Member
Joined: 16 years ago

I have an ePOs back end and would like to program my sx6600 that was reset to factory settings. I don't know how to access the machine communications flags in order to change them to communicate with ePOs. I need help with setting the flags via a direct connection and then change the flags once programming is completed to communicate via a phone line and modem. Any help that anyone out there can offer would be greatly appreciated.
SJ

Reply
1 Reply
Posts: 481
Reputable Member
Joined: 18 years ago

Hi,

IT all depends on the epos setup of the back office really, what is the back office software? Also do you know or can you see anywhere in the setup of the software a baudrate setting?

cheers

Reply
Share: