Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Share:
Notifications
Clear all

Re-programme - Uniwell DX-915

11 Posts
4 Users
0 Reactions
2,242 Views
Posts: 188
Estimable Member
Joined: 16 years ago

Uniwell UK are still going strong after being bought up a few months back!!

Reply
Posts: 2464
Member
Joined: 15 years ago

is Ali still on support desk?

Reply
Posts: 188
Estimable Member
Joined: 16 years ago

The famous Ali, he left last year before there collapse. They were all working part time for about a year. The Uniwell brand was taken on by Geller. A couple of the staff have been kept on but the office is in London.

Reply
Posts: 9
Topic starter
Active Member
Joined: 14 years ago

Thanks folks,
The key was not 25***18.
The key had been reset and an even higher level key was needed.
Friendly dealer supplied.
Now it has been re-set to 25
*****18.
Thanks

John

Reply
Posts: 188
Estimable Member
Joined: 16 years ago

There is no such thing as a higher engineers code!

If your talking about the code that works in blind, this is completely different to the engineers code. This code is needed when clearing the flash or performing an emergency ram clear etc.

Reply
Page 2 / 3
Share: