Welcome to EpoS Wizard!
Hello,
I bought the cash register Uniwell px 6750 version 03 and I would like to program my register with plm 2000. 
I tried to communicate with my register (key in Z1/P position), but I always get a ECR time-out error, so I think the communication fails. 
The program was downloaded from http://www.ntsecr.co.za/downloads.html
I'm not sure I have the correct cable, because I used a cable that was I already had. 
Could that be the problem? And if it is so, where could I get the right cable?
Thanks in advance for the solution 
Hi,
This is the cable you should be using:
Is this anything like what you are currently using?
There may also be a couple of settings you will need to change to get the communications up and running but obviously the cable is the most important part.
Regards
Nemesis
Hi,
This is the cable you should be using:
Is this anything like what you are currently using?
There may also be a couple of settings you will need to change to get the communications up and running but obviously the cable is the most important part.
Regards
Nemesis
I don't know If I have the right cable, and I surched for such a cable on the internet, but I can't find the right cable. The only thing I've found is a "male to usb" cable. But I don't think that should work eather.
Do you have any idea where I could get such a cable.
Another thing, I put the register in Z1/P position. Is that OK or not, because I'm not sure that's the right position. Or do I have to do anything else on the register?
I already checked the com settings, and they seem to be alright according the help manual.
Hi,
I also had this problem 
, so I made up the lead myself .
You can purchase the connections from Maplin or RS .
Mick
Hi,
Mick is right, you won't find a cable anywhere as it's specific to uniwell machines. The only option you have is to pay someone to make one or solder one up yourself.
