Welcome to EpoS Wizard!
So far I am only connecting from PC and not sure the cable is the correct one (Do Uniwell have their own pin configuration or is it standard RS232)
They have their own. Somebody on here be able to provide you with that. Else I'll scan in a diagram tomorrow. Are you trying to use Ethernet or serial for the link to PC, I'm confused?
For getting the tills on IRC you still need to set SP-200 (machine ID's) and SF-45 (Use Ethernet) in addition to the IP's and MAC addresses (which you can find on the ethernet boards). If your using ethernet printers you'll need to set IPs aswell and you'll also have to set KP BASE flag in the the IP settings on the till. Usually 9100 I think?
It's important to set up SF45 before doing any programming on the till otherwise it can play about with allocated memory (SP-112 MAXIMUMS). It's important to makes sure Maximums are the same on all your tills fi they're to hold the same program.
Hi,
This is the cable spec as mentioned by Skiver:
are these specifications applicable to those cables too that are of same category but somewhat cheap???
plm 2000 does not support the 06 model tills
If you find me helpful, then why not buy me a house in the bahamas!
or Alternatively a pint using the Donations Button! I'll let you decide which
