Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
Cash Register Secti...
Uniwell Cash Regist...
DX-895, PC to ECR v...
 
Share:
Notifications
Clear all

DX-895, PC to ECR via RS 232

 
Uniwell Cash Register Equipment
Last Post by Skiver 16 years ago
2 Posts
2 Users
0 Reactions
716 Views
Posts: 2
 Folke
Topic starter
May 03, 2009 9:47 pm
(@folke)
New Member
Joined: 16 years ago

When i was trying to upgrade my ECR, trough Flash ROM, everything disappeard and now im unable to contact my ECR. Its not possible to change any settings what so ever. Looks like the "software" has been erased.

I was told that i'm able to write it back trough RS232-B connection, but i cant manage to get any response when i connect the ECR to my PC. (Using Unilite software on my PC)

Any ideas why im having this problem? or how i can rewrite the software? (Im thinking it might have the wrong kind of cable?)

Reply
1 Reply
Posts: 109
 Skiver
May 05, 2009 6:33 pm
(@skiver)
Estimable Member
Joined: 16 years ago

If you've flashed the till you will have lost any data.
After flashing you should perform a destructive Ram test and then Init All data. You can then start programming from scratch or dump a program into the till.

Reply
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)