Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Forums
Cash Register Secti...
Sharp Cash Register...
Totals not resettin...
 
Share:
Notifications
Clear all

Totals not resetting afer Z reading XE-A213!!

 
Sharp Cash Register Equipment
Last Post by CGI EPOS 15 years ago
4 Posts
2 Users
0 Reactions
929 Views
Posts: 3
 drongo22
Topic starter
Feb 12, 2010 6:58 pm
(@drongo22)
New Member
Joined: 15 years ago

Hello, I programmed a XE. I set the printer to journal mode to save paper. At the end of the day the owner does a 'Z' reading BUT for some reason it does not show just that days totals, it shows the total the till has taken since it was installed!! Is there a way of the Z reading just showing the daily totals??

Thanks :)

Reply
3 Replies
Posts: 451
 CGI EPOS
Feb 12, 2010 8:55 pm
(@cgi-epos)
Reputable Member
Joined: 16 years ago

key to pgm

PRESS ST - 64 (X) - 11111100 ST - TL/NS

THAT WILL DISABLE ALL GRAND TOTALS INC TRAINING GT...

all Donations to Peter@cgiepos.co.uk

Reply
Posts: 3
 drongo22
Topic starter
Feb 13, 2010 9:28 pm
(@drongo22)
New Member
Joined: 15 years ago

Thanks for that, will try tomorrow..I assume where you used the minus symbol is just there to separate the steps taken, and not actually look for a minus key??

Thanks :)

Reply
Posts: 451
 CGI EPOS
Feb 14, 2010 5:07 pm
(@cgi-epos)
Reputable Member
Joined: 16 years ago

yes thats right..

PRESS ST button then type 64 then press (X)button type code 11111100 press ST then TL/NS

Peter

all Donations to Peter@cgiepos.co.uk

Reply
Forum Jump:
  Previous Topic
Next Topic  
Share:
All Rights Reserved © 2021
Terms and Conditions
Discussion Rules
Privacy Policy
Cookie Policy (UK)