Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Share:
Notifications
Clear all

Sps-520FT Screen wont turn off at Reg Off.

4 Posts
2 Users
0 Likes
506 Views
Posts: 0
Joined: 1 second ago

I have picked up a Sps-520FT and apart from a failed back up battery in full working order except the touch screen wont turn off at Reg Off position. Rear screen goes off and keyboard becomes inactive suggesting key switch assembly is fine. Running firmware 1.17.
Screen is fully functional as is the till and programming.
Any clues ? Been thro the settings extensively.
I have 2 530s and another 520 with slightly newer firmware that do not carry this issue.

Reply
3 Replies
Posts: 2464
Member
Joined: 15 years ago

does it print?
(silly question i know - but these things kind of "queue" commands if you run out of paper)
if theres no paper in it, you may find it will suddenly burst into life once a roll is installed, the platen is closed firmly and the c button is pressed.

Reply
Posts: 0
Joined: 1 second ago

Yes it all prints fine.
I've solved the issue.
The flexi ribbon between screen and board had an issue. The ends of the ribbon were slightly detached so not connecting properly. Carefully trimming and inserting carefully solved the issue completely.

Reply
Posts: 2464
Member
Joined: 15 years ago

well theres one to add to the memory banks lol Thanks for gettung back to us.
was it the fine brown one? or the more substantial white one?

Reply
Share: