Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Notifications

Clear all

SAM4S SPS-2000 Memory Setup / DK port voltage

Sam4s Cash Register Equipment

Last Post by dbr10 12 years ago

1 Posts

1 Users

0 Reactions

547 Views

Posts: 10

dbr10

Topic starter

Feb 28, 2013 7:31 am

(@dbr10)

Active Member

Joined: 12 years ago

Hi,
Just picked up a 2nd hand SPS2000 that had been used in a retail environment with 10,000 plus PLU's etc.

I'm planning to use in a Cafe / Bistro with 14 tables, maximum of 20 staff , clerk logon via Dallas key and electronic journal on. Any recommendations as to initial memory allocation? I estimate needing no more than 200 PLU's, but some will have modifiers/condiments.

Don't want to get it wrong and discover I've got to start programming all over again!

Also - Is the DK port on the unit +12v or +24v? Is is normal to drive the drawer on these units directly from the base, or via an attached printer? Any recommendations for a compatible printer ?

Many Thanks
Dave B.

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed

Welcome to EpoS Wizard!

SAM4S SPS-2000 Memory Setup / DK port voltage

All Rights Reserved © 2021

Terms and Conditions

Discussion Rules

Privacy Policy

Cookie Policy (UK)