Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Share:
Notifications
Clear all

GIANT-100D Printer Issues

1 Posts
1 Users
0 Reactions
1,333 Views
Posts: 32
Topic starter
Eminent Member
Joined: 17 years ago

Just got hold of a couple of these printers.

First off, I cannot find the default password to the web configuration page of the GIANT. Does not seem to be written in any of the manuals!

Secondly, trying to get the SPS-2000 to print correctly is not happening. Prints OK, but does not cut automatically. There does not seem to be a GIANT-100 setting in the Printer Driver section of the SPS-2000. I see there are generic printer options, but I cannot find any reference to the START and CANCEL codes.

Finally, logo printing, oddly, the printer chooses to print the top logo as set in the GIANT Utility, but also decides to print the same logo at the bottom of the print out, even though it is disabled in the GIANT Utility.

Anyone have any clues on any of the above?

Cheers :)

Reply
Share: