Welcome to EpoS Wizard!
how to set casio tk 2300 date/time? i am trying to find manual . but casio want £5 just for the answer .
so i found and i downloaded an older manual for ce-2400 which shows
turn key to x
sub total
hh mm
x/date/time
c
(like wise for date but its YY MM DD)
or from a pcr t2000
turn key to pgm
1
sub total
hh mm
x/date/time
c
(like wise for date but its YY MM DD)
so the question is which one shall i follow? lol. thanks.
1. Turn key to PGM
2. Enter HHMM and press X/TIME
3. Press C to clear screen
4. Enter YYMMDD and press X/TIME
5. Press C to clear screen
6. Turn back to reg
Regards
Dave
Nice one i will try it. Reason is my till seems to be jumping dates. For example, the date yesterday was 5/12 but the date on the receipts throughout the night say 6/12 . then the journal roll ran out so I turned the key to off and changed the roll. This was prior 12AM . Its for a pub so we run end of day report obviously after 12AM after last customer leaves. Then the date on the report shows up as for the 7/12. LOL . So my figures are 2 days ahead 
Quick question about back up battery. As long as their is power to the till via the AC . I can still go ahead change the batteries if the till display shows 'L' and it wont loose all my item names /prices . So as I am changing the batteries the till will stil get power from the mains even in off mode ?
Changing the battery...
There is one battery connected to the main board so you will need to leave the till on whilst changing it, so be careful. The battery is attached to cables connecting it to the main board but the connector on the main board disconnects. So you will need to solder these cables to the new battery. I would also leave it in Reg mode.
Once changed make sure you leave the till on so the new battery can be fully charged.
Dave
date/time change work perfect. many thanks.
I see , I had thought the batteries were a simple double AA change over . Obviously not, so I think if it aint broke , I wont touch it . LOL
