Welcome to EpoS Wizard!

As you’ll no doubt have noticed if you’ve previously visited any time in the last decade or two, EPoS Wizard has undergone some quite drastic changes!

YOU WILL BE REQUIRED TO CHANGE YOUR PASSWORD
(See below if you are unable to receive a password reset request)

Read on »

Share:
Notifications
Clear all

Casio CE-T300 Error message E004

7 Posts
4 Users
0 Reactions
1,777 Views
Posts: 9
Topic starter
Active Member
Joined: 15 years ago

HI
I HAVE A PROBLEM WHITH MY CASIO CE-T300 I HAVE FOLOW THIS STEP

1.Turn off the cashregister.
2.Turn the key to PGM.
3.Hold down the "Receipt feed" button and turn on the cashregister.
4.Hold down the "Receipt feed" button about 5sec and when you let it go there should appear "FFFFFFFFFF" in the display.
5.Push the "SUB TOTAL" button and wait for a receipt.
THE DISPLAY appear

P1 0

BUT I DONT KNOW HOW I SET THE DATE TIME ..........

THANKS ALL

Reply
6 Replies
Posts: 451
Reputable Member
Joined: 16 years ago

Turn key to pgm. Enter date then press x/time button
Try day month year. Ie 160210. You might have to mix it up to get it right could be month day year etc.

Reply
Posts: 9
Topic starter
Active Member
Joined: 15 years ago

Thank you so much
i follow this step to set date and time but note work
and the display apear
p1 0
on pgm mode
pleas help me

Reply
Posts: 675
Honorable Member
Joined: 17 years ago

Hi. This machine has no currency system in it, so I would say it has been stored too long and you have lost everything. It is best to take it to a dealer to get all of the system settings re-programmed.

Reply
Posts: 9
Topic starter
Active Member
Joined: 15 years ago

i find solution
Set the Mode switch to OFF position.
2. While holding down the <Journal Feed>, turn the Mode switch to PGM position.
3. You should see "0000000000" on the display.
Enter the 14 digit code from work sheet FC
00000000011511
Press <SUBTOTAL>

BUT I HAVE PROBLEM WHIH clerk .I WANT TO REMOVE CLERK CODE

Reply
Page 1 / 2
Share: